Turbulent heat fluxes were measured far downstream of a fine heating wire stretched spanwise across a curved, uniform shear flow. The turbulence was approximately homogeneous and the overheat small enough to be passive. Strong destabilizing and stabilizing curvature effects were produced by directing the shear toward the center of curvature and away from the center of curvature, respectively. The dimensionless turbulent shear stress was strongly affected by the flow curvature, but the dimensionless components of the turbulent heat flux were found to be relatively insensitive.
Issue Section:
Technical Briefs
1.
Gibson, M. M., and Servat-Djoo, K., 1981, “Measurements in the heated turbulent boundary layer on a mildly curved concave surface,” 5th Symposium on Turbulent Shear Flows, Ithaca, NY, pp. 14.7-14.12.
2.
Gibson
M. M.
Verriopoulos
C. A.
1984
, “Turbulent boundary layer on a mildly curved convex surface: Part 2, Temperature field measurements
,” Expt. in Fluids
, Vol. 2
, pp. 73
–80
.3.
Hollingsworth
D. K.
Moffat
R. J.
Kays
W. M.
1992
, “The Effect of Concave Surface Curvature on the Turbulent Prandtl Number and the Thermal Law of the Wall
,” Exp. Thermal Fluid Set
, Vol. 5
, pp. 299
–306
.4.
Holloway
A. G. L.
Tavoularis
S.
1992
, “The effect of curvature on sheared turbulence
,” J. Fluid Meek
, Vol. 237
, pp. 569
–603
.5.
Karnik
U.
Tavoularis
S.
1987
, “Generation and manipulation of uniform shear with the use of screens
,” Experiments in Fluids
, Vol. 5
, pp. 247
–254
.6.
Karnik
U.
Tavoularis
S.
1989
, “Measurements of heat diffusion from a continuous line source in a uniformly sheared turbulent flow
,” J. Fluid Meek
, Vol. 202
, pp. 233
–261
.7.
Kim
J.
Simon
T. W.
1988
, “Measurements of the Turbulent Transport of Heat and Momentum in Convexly Curved Boundary Layers: Effects of Curvature, Recovery and Free-Stream Turbulence
,” ASME Journal of Turbomachinery
, Vol. 110
, pp. 80
–87
.8.
Tavoularis
S.
Corrsin
S.
1981
, “Experiments in Nearly Homogeneous Turbulent Shear Flow With a Uniform Mean Temperature Gradient: Part 1
,” J. Fluid Meek
, Vol. 104
, pp. 311
–347
.9.
You, S. M., Simon, T. W., and Kim, J., 1986, “Boundary Layer Heat Transfer and Fluid Mechanics Measurements on a Mildly-Curved Convex Wall,” Proc. 8th Int. Heat Transfer Conf., Vol. 3, pp. 1089–1091.
This content is only available via PDF.
Copyright © 1999
by The American Society of Mechanical Engineers
You do not currently have access to this content.