This paper describes the application of a variable-speed drive for the speed-sensing element of a conventional hydro-governor which makes it possible to measure accurately the deflection of the speeder rod for a given speed change from normal. When this characteristic is determined in the field, changes can be made to the control springs if necessary, to make all machines consistent. The device may also be applied to measure directly both the permanent and temporary speed droops of the governor and allow these quantities to be readjusted to the desired values. The advantage of this method of adjustment is that it permits all the work to be carried out with the main machine shutdown. The variable-speed drive consists of a small motor-generator set which supplies direct-current power to a rotary converter, which in turn delivers low-frequency alternating-current power to the speed-sensing motor on the governor. The rotary converter and the motor-generator set are controlled by a system which gives precise control over the speed which is measured by an accurate tachometer.
Skip Nav Destination
Article navigation
January 1965
This article was originally published in
Journal of Engineering for Power
Research Papers
Adjustment of Hydro-Governor Characteristics Using Separate Drive for the Speed-Sensing Element
L. M. Hovey
L. M. Hovey
Manitoba Hydro, Winnipeg, Manitoba, Canada
Search for other works by this author on:
L. M. Hovey
Manitoba Hydro, Winnipeg, Manitoba, Canada
J. Eng. Power. Jan 1965, 87(1): 13-17 (5 pages)
Published Online: January 1, 1965
Article history
Received:
August 7, 1963
Online:
January 10, 2012
Article
Article discussed|
View article
Connected Content
Citation
Hovey, L. M. (January 1, 1965). "Adjustment of Hydro-Governor Characteristics Using Separate Drive for the Speed-Sensing Element." ASME. J. Eng. Power. January 1965; 87(1): 13–17. https://doi.org/10.1115/1.3678129
Download citation file:
14
Views
Get Email Alerts
Cited By
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Semicompliant Force Generator Mechanism Design for a Required Impact and Contact Forces
J. Mechanisms Robotics (November,2010)
Electromagnetic Coupling in a dc Motor and Tachometer Assembly
J. Dyn. Sys., Meas., Control (September,2004)
Energy Economy With a Variable Speed Drive in an Oxygen Trim Controlled Boiler House
J. Energy Resour. Technol (March,2005)
New Machines for Creep and Creep-Rupture Tests
Trans. ASME (February,1945)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Formulation and Dynamic Behavior of Electrical Systems
Introduction to Dynamics and Control in Mechanical Engineering Systems
Accuracy of an Axis
Mechanics of Accuracy in Engineering Design of Machines and Robots Volume I: Nominal Functioning and Geometric Accuracy