Accuracy when assessing mistuned forced response analyses is still a major concern. Since a fully coupled analysis is still very computational expensive, several simplifications and reduced-order models (ROMs) are carried out. The use of a reduction method, the assumptions and simplifications, generate different uncertainties that challenge the accuracy of the results. Experimental data are needed for validation and also to understand the propagation of these uncertainties. This paper shows a detailed mistuned forced response analysis of a compressor blisk. The blisk belongs to the Purdue Three-Stage (P3S) Compressor Research Facility. Two different stator–rotor–stator configurations of 38 and 44 upstream stator vanes are taken into consideration. Several loading conditions are analyzed at three different speed lines. A ROM known as subset nominal mode (SNM), has been used for all the analyses. This reduction takes as a basis a set of modes within a selected frequency spectrum. It can consider a complete family of modes to study the disk–blade modal interaction. A detailed comparison between the predicted and measured results has been performed, showing a good agreement for the high loading (HL) conditions.
A Mistuned Forced Response Analysis of an Embedded Compressor Blisk Using a Reduced-Order Model
Contributed by the Structures and Dynamics Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received July 31, 2018; final manuscript received August 8, 2018; published online October 11, 2018. Editor: Jerzy T. Sawicki.
- Views Icon Views
- Share Icon Share
- Search Site
Gutierrez Salas, M., Petrie-Repar, P., Kielb, R. E., and Key, N. L. (October 11, 2018). "A Mistuned Forced Response Analysis of an Embedded Compressor Blisk Using a Reduced-Order Model." ASME. J. Eng. Gas Turbines Power. March 2019; 141(3): 032505. https://doi.org/10.1115/1.4041280
Download citation file: