0
RESEARCH PAPERS

A Quantitative Evaluation of the Frequency-Response Characteristics of Active Human Skeletal Muscle In Vivo

[+] Author and Article Information
G. I. Zahalak, S. J. Heyman

Department of Mechanical Engineering, Washington University, St. Louis, Mo. 63130

J Biomech Eng 101(1), 28-37 (Feb 01, 1979) (10 pages) doi:10.1115/1.3426220 History: Received July 25, 1978; Online October 21, 2010

Abstract

This paper describes an investigation of the frequency-response characteristics of active human skeletal muscle in vivo over the frequency range 1 Hz to 15 Hz. The applied force, forearm position, and surface electromyograms (from biceps, triceps, and brachioradialis) were recorded simultaneously in four normal adult male subjects for small oscillations of the forearm about a mean position of 90 deg flexion. Two modes of oscillatory behavior are discussed: externally forced oscillations under constant muscle force and voluntary oscillations against an elastic resistance. The observed amplitude and phase relations are presented herein and are compared to the response predicted by a simple model for neuromuscular dynamics. It appears that the small amplitude frequency response of normal skeletal muscle in vivo can be represented by a second order model. The main muscle parameters of this model are a muscular stiffness K, two time constants τ1 and τ2 associated with contraction dynamics, and a time delay τ: typical values of these parameters at moderate contraction levels (approximately 20 percent of maximum voluntary effort) are K = 100 N · m/rad, τ1 and τ2 = 50 ms, and τ = 10 ms. Reflex feedback under forced-oscillation conditions was also examined and may be characterized by a gain parameter (ΔE/Δθ), the ratio of the surface EMG amplitude to the angular displacement of the forearm, and the phase by which the EMG leads muscle stretch. The reflex EMG is observed to lead muscle stretch at all frequencies between 1 Hz and 15 Hz. The muscle stiffness K and the reflex gain parameter (ΔE/Δθ) are approximately proportional to the average force of contraction.

Copyright © 1979 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In